High brightness strobe LED warning light with high visibility and no maintenance in use. External rotating lampshade, while maintaining high brightness, without losing the classic visual design, built-in unique filter system can effectively diffuse the LED light. Power consumption is about half that of incandescent bulbs. (100V/200V AC), protection class IP54. multi-layer LED arc around the design, uniform light, high brightness, no dead spots, no poor contact. Can be continuous rapid three strobe flash form, produce a strong visual impact, better warning effect.
When using AC power supply wiring do not need to consider the positive and negative poles, independent of the color.
When using DC power supply, the black power cable is connected to the negative pole.
The structure of this product is indoor general structure, when used indoors, it can be installed in any way.
When using this product outdoors, try to avoid the place where it is wet by rain and vertical installation.
Try to choose the installation where there is less moisture, dust, vibration and shock.
If the voltage used is higher or lower than the rated voltage, it may shorten the service life of the product or lead to abnormal operation of the product. The voltage used must be controlled to 5% above or below the rated voltage.
Lampshade or base surface contact with costume chemicals will damage the product, resulting in deformation or fading, the user should pay special attention to the phenomenon.
Do not put the product strong impact, which will cause a series of problems such as product short-circuit failure.
Do not expose the product on the wire mandatory elongation which is one of the reasons for product failure.
